Oled crashes when i move my LXR

edited May 2015 in Troubleshooting
My problem is that if i have a sequence running then when i turn a knob a big faster or even a bit stronger and the lxr moves a bit it crashes the display the display stops working but the sound is still 100%. The knobs still works but i cant see anything on the display

What would you recomend? its a cold solder what do you recomend?
thank you so much


  • Yes, most likely it's a bad solder joint somewhere on the display connection. Try to resolder all of them.
  • edited May 2015
    i would take the case off, plug it in, and try to isolate the part that causes the corruption, starting with the oled by pushing on it, but it could be something else.
Sign In or Register to comment.